6J13 manganin alloy strip (0.19mm×25mm), a precision-engineered resistance alloy product from Tankii Alloy Material, is a thin-gauge functional strip crafted from Mn-Cu-Ni ternary manganin alloy. Through advanced vacuum smelting, multi-pass precision cold-rolling, and segmented annealing processes, this strip achieves ultra-tight dimensional control (0.19mm thickness ±0.002mm, 25mm width ±0.1mm) and consistent electrical properties.

• Alloy Grade: 6J13 (Chinese standard manganin precision resistance alloy; optimized for thin-gauge rolling performance)
• Dimensional Specification: 0.19mm thickness × 25mm width (customizable, but this fixed 规格 matches mainstream micro-component stamping dies)
• International Alignment: Performance aligned with DIN 17471 CuMn12Ni2 thin strips, with adjusted Mn content (12.0-13.0%) to enhance thin-gauge ductility
• Compliant Standards: GB/T 1234-2019 (resistance alloy strips) + GB/T 2059-2021 (copper alloy strips) + IEC 60404-8-2 (precision resistance components)
• Manufacturer: Tankii Alloy Material, certified to ISO 9001 and RoHS, with specialized thin-gauge alloy rolling lines (minimum rolling thickness 0.01mm)

• Thickness Precision for Miniaturization: 0.19mm thickness hits the “golden balance” for micro-devices–thinner than 0.25mm strips (reducing component volume by 24%) while avoiding the brittleness of ultra-thin strips (<0.15mm) that crack during stamping.
• Narrow Width for Batch Stamping: 25mm width matches 4-6 sets of micro-shunt stamping dies (each die size ~4mm) per strip, enabling one-time stamping of 2000+ micro-components per 100m strip–reducing material waste by 30% vs. using 50mm wide strips for small parts.

• Ultra-Fine Etchability: The strip’s uniform microstructure (grain size ≤20μm) and bright annealed surface (Ra ≤0.15μm) support ultra-fine chemical etching–minimum etched line width up to 0.02mm.
• Stable Stamping Consistency: After 5000 times of continuous stamping (simulating mass production), the strip’s thickness variation is <0.001mm, and the resistance deviation of stamped components is ≤0.05%.

• Material-Saving Design: The fixed 25mm narrow width eliminates secondary slitting (a common step for wide strips), reducing processing costs by 18% and shortening delivery cycles by 3-5 days.
• Dual-Temper Optional: Offers both soft (annealed, elongation ≥25%) and half-hard (elongation 15-20%) tempers for different processes.

• Consumer Electronics Fast-Charging: Micro-current shunts for 65W smartphone chargers (0.19mm thickness fits the charger’s slim design, 25mm width supports batch stamping of 4 shunts per strip).
• Wearable Health Sensors: Resistance elements for smart watch heart rate sensors (soft temper enables 0.38mm radius bending, narrow 25mm width reduces material waste).
• IoT Sensor Nodes: Micro-resistor networks for wireless temperature/humidity sensors (ultra-fine etchability supports 0.02mm line width).
• Automotive Micro-Electronics: Current-sensing strips for in-car USB charging modules (half-hard temper ensures stamping precision of contact points).

Tankii Alloy Material implements “micro-precision quality control” for 6J13 strips (0.19×25mm): each roll undergoes laser thickness measurement (100 sampling points/m), surface roughness inspection (per 5m segment), and micro-stamping simulation testing (100 samples per batch). Free samples (100mm×25mm, soft/half-hard temper optional) and micro-etching test reports are available upon request.